[crw-talk] Proposal for Ft McCoy

Thu Jan 24 09:57:04 CST 2019

If it works out timing wise I would also like to assist in the demo there.

Paul Rops

props at charter.net

From: crw-talk <crw-talk-bounces at crwoodturner.com> On Behalf Of John & Donna Griffiths
Sent: Wednesday, January 23, 2019 3:00 PM
To: crw-talk at crwoodturner.com
Subject: Re: [crw-talk] Proposal for Ft McCoy

I could not get the attachment to open.  Don't know what I did wrong.  But Re: Kris's comment, most likely we would have two lathes (three max) and probably a grinder which would be used infrequently so her point is well taken, and probably there will be multiple circuits as long as we don't use just one outlet for two lathes or two adjoining ones.  We can practice good extension cord usage by making sure we use one cord per lathe and use different outlets.

As I recall when I demoed at VA, we had no power issues.

Thanks for your work on this, Jim

John

On 1/23/2019 2:20 PM, Kristine Clough wrote:

Jim, 

The proposal looks pretty good.  One thing I might add is that those 6 outlets cannot be on the same circuit if it is 120 volt (Duane, how many circuits are needed?).  We do have at our disposal a junction box that runs off of 220 volt and then can provide power to those 6 lathes.

Sent from Yahoo Mail on Android <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature> 

On Wed, Jan 23, 2019 at 12:33 PM, James Bloomer

 <mailto:marine9096 at gmail.com> <marine9096 at gmail.com> wrote:

Good afternoon, I was able to speak to Ft McCoy about trying for a Demo/hands-on event on post. I was asked to write up an informal proposal for them to look at. I have drafted this rough proposal and ask for any additions or revisions needed since I have not had a chance to participate in a demo, so I may be missing a piece or two. Please suggest your revision on the thread versus the attachment so I don't have multiple version floating about.  

Many Thanks

-- 

James A. Bloomer

_________________________________________
Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
______
crw-talk mailing list
crw-talk at crwoodturner.com <mailto:crw-talk at crwoodturner.com> 
http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20190124/598c1d3d/attachment.html>