[crw-talk] Proposal for Ft McCoy

[John & Donna Griffiths]

I could not get the attachment to open.  Don't know what I did wrong.  
But Re: Kris's comment, most likely we would have two lathes (three max) 
and probably a grinder which would be used infrequently so her point is 
well taken, and probably there will be multiple circuits as long as we 
don't use just one outlet for two lathes or two adjoining ones.  We can 
practice good extension cord usage by making sure we use one cord per 
lathe and use different outlets.

As I recall when I demoed at VA, we had no power issues.

Thanks for your work on this, Jim

John

On 1/23/2019 2:20 PM, Kristine Clough wrote:
> Jim,
>
> The proposal looks pretty good.  One thing I might add is that those 6 
> outlets cannot be on the same circuit if it is 120 volt (Duane, how 
> many circuits are needed?).  We do have at our disposal a junction box 
> that runs off of 220 volt and then can provide power to those 6 lathes.
>
> Sent from Yahoo Mail on Android 
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>
>     On Wed, Jan 23, 2019 at 12:33 PM, James Bloomer
>     <marine9096 at gmail.com> wrote:
>     Good afternoon, I was able to speak to Ft McCoy about trying for a
>     Demo/hands-on event on post. I was asked to write up an informal
>     proposal for them to look at. I have drafted this rough proposal
>     and ask for any additions or revisions needed since I have not had
>     a chance to participate in a demo, so I may be missing a piece or
>     two. Please suggest your revision on the thread versus the
>     attachment so I don't have multiple version floating about.
>
>     Many Thanks
>
>     -- 
>     James A. Bloomer
>     _________________________________________
>     Use "Reply to All" or "Reply List" to reach the whole group,
>     "Reply" goes only to sender.
>     ______
>     crw-talk mailing list
>     crw-talk at crwoodturner.com <mailto:crw-talk at crwoodturner.com>
>     http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
>     Check the archive to make sure your message was sent:
>     http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
>
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20190123/be7230a7/attachment.html>