[crw-talk] cutn and turnin

[raaschb at charter.net]

Thank you sir. 

 

From: crw-talk <crw-talk-bounces at crwoodturner.com> On Behalf Of griff
Sent: Tuesday, August 8, 2023 9:10 AM
To: crw-talk at crwoodturner.com
Subject: Re: [crw-talk] cutn and turnin

 

Hey my friend, that's all right. Nice piece..I bet the hardest part was the
points on the business end, getting them evenly spaced and shaped. John

On 8/7/23 9:21 PM, raaschb at charter.net <mailto:raaschb at charter.net>  wrote:

New skill development for me, a meat tenderizer for a gift.  Maple mallet
head, hickory handle  approx. 5"X3"X2" head, 2 axis offset handle 11"
including tenon,  walnut wedge and plug. Mineral oil finish.  Tenderizer
head pointy things, bandsawn cut at 25 degrees in both directions.  Lots of
fixes er design opportunities along the way.

 

-raasch





_________________________________________
Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes
only to sender.
______
crw-talk mailing list
crw-talk at crwoodturner.com <mailto:crw-talk at crwoodturner.com> 
http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
Check the archive to make sure your message was sent:
http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20230808/86b93779/attachment.html>