[crw-talk] cutn and turnin

griff griff at mwt.net
Tue Aug 8 09:09:40 CDT 2023


Hey my friend, that's all right. Nice piece..I bet the hardest part was 
the points on the business end, getting them evenly spaced and shaped. John

On 8/7/23 9:21 PM, raaschb at charter.net wrote:
>
> New skill development for me, a meat tenderizer for a gift.  Maple 
> mallet head, hickory handle  approx. 5”X3”X2” head, 2 axis offset 
> handle 11” including tenon,  walnut wedge and plug. Mineral oil 
> finish.  Tenderizer head pointy things, bandsawn cut at 25 degrees in 
> both directions.  Lots of fixes er design opportunities along the way.
>
> -raasch
>
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20230808/f14ed80e/attachment.html>


More information about the crw-talk mailing list