[crw-talk] Fun project for Christmas

[Bob R]

Very nicely done. I like especially the subtle curve of branches from top to base. Nice sheen on the ornament.

Bob R, Sent from my Phone
On Nov 28, 2020 10:27 AM, Robert Patros <rjpatros05 at gmail.com> wrote:
>
> These are fun to make. I first made small ornament trees after reading Bob Rosand’s article that I accessed on his website. With this larger walnut blank, I used an 1/8” parting tool. The finish, applied with the lathe running at about 50 rpm, is Master’s Aerosol gloss lacquer. Then, applied Briwax on Liberon 0000 wool. 
>
> It was the first time I used spray lacquer. I got a little overzealous on the second coat and sprayed it on too thick. No problem. Let it dry for a while, sand it again, and start over. 
>
>
>
> Sent from my iPhone
> _________________________________________ 
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender. 
> ______ 
> crw-talk mailing list 
> crw-talk at crwoodturner.com 
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com 
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/