[crw-talk] VA Demo

[James Bloomer]

So plan for about 1-1.5 hour setup. How long do we want to go for? 3 hours
sound like a good length? Would have us done about 1630, with tear down and
clean up out by 1730. Then if interested I know an excellent BBQ place in
Tomah.

On Wed, Feb 20, 2019 at 11:30 AM John & Donna Griffiths <griff at mwt.net>
wrote:

> So that means the VA members, patients or whatever they are called will be
> there at 13:30?  If so I would say one hour set up since we have to carry
> lathes, tools and wood inside and figure out where we plug them in etc.  So
> we factor in time to load the machines, travel and grab lunch too.
>
> I suggest we plan two or three club members per lathe so we can work in
> shifts.  That would minimize the hassles of moving equipment.
>
> James, I think your leadership on this project is one of the things that
> makes CRW such a good club.  Thanks for all you do.  A good number of our
> members are veterans and value the services VA offers.
>
> John
> On 2/20/2019 10:55 AM, James Bloomer wrote:
>
> Got word back March 30 at 1330(130pm) is good. When would we need to be
> there for setup and how long did we want to go?
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing listcrw-talk at crwoodturner.comhttp://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes
> only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent:
> http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
>


-- 
James A. Bloomer
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20190221/6f4bdc21/attachment.html>