[crw-talk] VA Demo

[John & Donna Griffiths]

So that means the VA members, patients or whatever they are called will 
be there at 13:30?  If so I would say one hour set up since we have to 
carry lathes, tools and wood inside and figure out where we plug them in 
etc.  So we factor in time to load the machines, travel and grab lunch too.

I suggest we plan two or three club members per lathe so we can work in 
shifts.  That would minimize the hassles of moving equipment.

James, I think your leadership on this project is one of the things that 
makes CRW such a good club.  Thanks for all you do.  A good number of 
our members are veterans and value the services VA offers.

John

On 2/20/2019 10:55 AM, James Bloomer wrote:
> Got word back March 30 at 1330(130pm) is good. When would we need to 
> be there for setup and how long did we want to go?
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20190220/999da04d/attachment.html>