[crw-talk] Any ideas

[Ken Grunke]

This may seem a bit drastic, but I've closed up cracks by forcing 
carpenter's glue (Titebond, etc) into the crack with compressed air (or 
just blowing it in with a straw) then soaking the piece in water for 
just the minimal time needed to close the crack. Put scotch tape over it 
to keep the glue from seeping out. Of course, the bowl will need to be 
resanded.

On 7/3/23 11:00, Robert Patros wrote:
> Good morning,
> I thought I could get beyond this crack but to no avail. I’m trying to think of a way to enhance it but not sure of the best approach, or, just leave it. It’s barely noticeable on the inside. Currently unfinished.
> Any thoughts?
>
>
>
>
>
> Sent from my iPhone
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent:http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20230703/c5f0bef7/attachment.html>