[crw-talk] cutn and turnin

[Egan, Richard]

Bob that is very nice. I would like to see your jig for cutting the points grid.

From: crw-talk <crw-talk-bounces at crwoodturner.com> On Behalf Of raaschb at charter.net
Sent: Monday, August 7, 2023 9:22 PM
To: CRW-Talk at crwoodturner.com
Subject: [crw-talk] cutn and turnin

CAUTION: This email originated from outside of Western Technical College. Do not click links or open attachments unless you recognize the sender and know the content is safe.

New skill development for me, a meat tenderizer for a gift.  Maple mallet head, hickory handle  approx. 5"X3"X2" head, 2 axis offset handle 11" including tenon,  walnut wedge and plug. Mineral oil finish.  Tenderizer head pointy things, bandsawn cut at 25 degrees in both directions.  Lots of fixes er design opportunities along the way.

-raasch
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20230808/1befcd1d/attachment.html>