[crw-talk] Missing part for powermatic lathe

[Kristine Clough]

Hi Everyone,
We are missing (or we just can't find it) the lifting device for the powermatic lathe.  It is a flat S shaped 1 inch square bar for putting the wheels on and off the lathe.  If you helped us move, please think back if you remember seeing it or look around to see if it may have been left in a vehicle by mistake.   
Thanks for looking and thinking.  Hope to see you tomorrow. 
Kris

Sent from Yahoo Mail on Android 
 
  On Fri, Oct 14, 2022 at 5:00 PM, Bob R<raaschb at charter.net> wrote:   _________________________________________
Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
______
crw-talk mailing list
crw-talk at crwoodturner.com
http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20221015/fccfba8b/attachment.html>