[crw-talk] FW: Looking for advise on coring tool

[Daniel Check]

Jim had a oneway easy core system.  I know they are made for smaller
lathes.  They are easy to learn. You might want to look into the
requirements.
Dan Check.

On Sun, Nov 13, 2022 at 11:34 PM Bob Raasch <raaschb at charter.net> wrote:

> Paul,
>
> Do you have enough power? If so, the rig that Jim Frank had might be a
> consideration. Can’t recall the name of it.  John Clough may know?  BR
>
>
>
> *From:* crw-talk <crw-talk-bounces at crwoodturner.com> *On Behalf Of *
> props at charter.net
> *Sent:* Sunday, November 13, 2022 5:20 PM
> *To:* crw-talk <crw-talk at crwoodturner.com>
> *Subject:* [crw-talk] FW: Looking for advise on coring tool
>
>
>
>
>
>
>
>
>
> I have a 14in Jet Lathe and I am looking at purchasing a bowl coring add
> on too my Jet.
>
>
>
> Does anyone have any recommendations in this area?
>
>
>
> Paul
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes
> only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent:
> http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20221114/7ad8571d/attachment.html>