[crw-talk] Vase

[John & Donna Griffiths]

That is beautiful.

Did you glue on the lower rings then turn the lower part before gluing 
on and turning the upper rings?  Seems like it would be hard to get a 
really nice shape and finish on the inside of the lower part if you 
tried to deep hollow the whole thing after it was all glued up.

------ Original Message ------
From: "Robert Patros" <rjpatros05 at gmail.com>
To: "Membership mailing list for the AAW Chapter Coulee Region 
Woodturners." <crw-talk at crwoodturner.com>
Sent: 9/4/2021 6:26:09 PM
Subject: Re: [crw-talk] Vase

>Thanks, Bob! I’m learning!
>
>Sent from my iPhone
>
>>  On Sep 4, 2021, at 6:24 PM, Bob Raasch <raaschb at charter.net> wrote:
>>
>>  Nice job on this segmented hollow form.  Looks like a challenge.  Bob
>>
>>  -----Original Message-----
>>  From: crw-talk <crw-talk-bounces at crwoodturner.com> On Behalf Of Robert Patros
>>  Sent: Saturday, September 4, 2021 9:05 AM
>>  To: crw-talk at crwoodturner.com
>>  Subject: [crw-talk] Vase
>>
>>  This is hickory. Didn’t turn out like the pattern suggested, but I’m continuing to find segmental turning fun and challenging. On to another project.
>>
>>
>>
>>  _________________________________________
>>  Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
>>  ______
>>  crw-talk mailing list
>>crw-talk at crwoodturner.com
>>http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
>>  Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
>
>_________________________________________
>Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
>______
>crw-talk mailing list
>crw-talk at crwoodturner.com
>http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
>Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/