[crw-talk] Platter Demo

[Robert Patros]

Nicely done, Duane! And great job on your demo!! 

Sent from my iPhone

> On Oct 3, 2021, at 7:54 AM, wisawdust at charter.net wrote:
> 
> Those of you who were at my platter demo at the last meeting may recall that I had an old, very hard piece of oak that I was turning.  Being as hard and old, the oak was causing some problems. There were some time constraints, so I could not finish the platter.  Here are three pictures of the finished product.  The first one is looking at the top.  If you look closely, you can see the two grooves on the rim have had some texturing done to them.  I used the Decorating Elf for these.  The second shows the bottom and the third shows a side view.
> 
> I also mentioned using a couple adapters which make recentering a piece off a chuck easier.  These two adapters can be found at Craft Supplies.  The first one is called Reverse Chucking Alignment Adapter, page 56 of new catalog, part number 979-365, you specify thread size, price $29.95.  This one utilized the No. 2 Morse Taper in the tail stock.  The second one mounts on a One Way, PowerMAtic or Robust live center utilizing the threads.  This is called the Revolving Center Chuck Adapter, part number 104-631, page 61 of new catalog, price $42.95
> 
> Duane
> <Oak Platter Top.jpg>
> <Oak Platter Bottom.jpg>
> <Oak Platter Side.jpg>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/