[crw-talk] Pen finishing question

[Robert Patros]

Thanks, Joe. I always use CA on wood, but wasn’t sure about applying it to the acrylic. When sanding off the acrylic will scratch. 

Sent from my iPhone

> On Nov 13, 2020, at 11:42 AM, Joseph W. Baker JR. <msgjbaker at gmail.com> wrote:
> 
> 
> I have used CA finish for those 
> 
> JW Baker
> 
>> On Fri, Nov 13, 2020, 11:36 AM Robert Patros <rjpatros05 at gmail.com> wrote:
>> I came across a pen blank that is half acrylic and half wood. It drilled and turned fine. As I didn’t think I could finish it like I would have if it would have been all acrylic or all wood,  I wet sanded, applied friction polish, and the buffed. Ok result. 
>> Any suggestions?
>> 
>> 
>> Sent from my iPhone
>> _________________________________________
>> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
>> ______
>> crw-talk mailing list
>> crw-talk at crwoodturner.com
>> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
>> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20201113/b46b019b/attachment.html>