[crw-talk] Bark edge goblet

[Ken Grunke]

Thanks, John. I was wondering if my 2 posts actually reached the group!

Ken Grunke

On 8/3/20 3:44 PM, John & Donna Griffiths wrote:
>
> Whoa Ken, that is a dandy!  Thanks for posting, John
>
> On 8/2/2020 6:30 PM, Ken Grunke wrote:
>> This one I got lucky with. Must have been winter-cut. 5 1/2" tall, 4" 
>> across the rim. Finished with wipe-on poly. It's been two years since 
>> I turned it, so has had the test of time.
>>
>>
>> _________________________________________
>> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
>> ______
>> crw-talk mailing list
>> crw-talk at crwoodturner.com
>> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
>> Check the archive to make sure your message was sent:http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20200803/472d57f4/attachment.html>