[crw-talk] FW: Bowl turning

[John & Donna Griffiths]

Well folks, someone else can grab this opportunity, my lathe has a 16" 
swing and I am not set up for outboard turning.  Thanks Duane and A 
Line, John

On 4/13/2020 8:38 AM, wisawdust at charter.net wrote:
>
> I received this e-mail via A-Line.  This guy's wife is a 
> photographer.  She would like a bowl, at least 18" in diameter and at 
> least 4" thick.  Contact him if yo interested.
>
> Duane
>
> -----------------------------------------
>
> From: "Collin Radke"
> To: "wisawdust at charter.net"
> Cc:
> Sent: Monday April 13 2020 6:58:14AM
> Subject: Bowl turning
>
> Hey Duane my name is Collin I talked to you last week on the phone 
> about getting a bowl turned from you or someone in your group.  The 
> dimensions would be nice to be over 18" dia.  Depth over 4".  Let me 
> know what you think and how much it would cost.  Thanks again.   This 
> is what she has now for size.  Its 18" dia.  4" deep
>
>
>
>
> Sent from Yahoo Mail on Android 
> <https://go.onelink.me/107872968?pid=InProduct&c=Global_Internal_YGrowth_AndroidEmailSig__AndroidUsers&af_wl=ym&af_sub1=Internal&af_sub2=Global_YGrowth&af_sub3=EmailSignature>
>
> _________________________________________
> Use "Reply to All" or "Reply List" to reach the whole group, "Reply" goes only to sender.
> ______
> crw-talk mailing list
> crw-talk at crwoodturner.com
> http://crwoodturner.com/mailman/listinfo/crw-talk_crwoodturner.com
> Check the archive to make sure your message was sent: http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://crwoodturner.com/pipermail/crw-talk_crwoodturner.com/attachments/20200414/b6d44f00/attachment.html>